Auto Setup For Dos - IBM T541A User Manual

Auto Setup for DOS

If the monitor is in standby
mode (STANDBY ON), it
may automatically turn off while
you are waiting for it to warm up.
If this happens, switch off the
monitor and switch it on again
after a few seconds.
If you are using PC-DOS/
V, change to U.S. mode by
typing 'CHEV US' and pressing
ENTER at the command
prompt.
You must use DOS when
you run DOS Auto Setup.
The size and diversity of
the dot pattern varies with
the screen resolution.
11
1. Turn on the monitor first; then the PC.
If the message CHECK SIGNAL CABLE is displayed, or if nothing is
displayed check:
• that the video interface cable is connected properly.
• the correct video adapter card is installed.
• the correct supported display mode is selected for your PC.
2. Wait approximately 15 minutes, until the monitor warms up.
3. Insert the User's Guide and Installation Files CD into the computer CD-
ROM drive.
4. Display the command prompt screen of the DOS full-screen display.
5. Type d:\ (change the drive letter to match your CD-ROM drive if it is not
drive D).
6. Type 'TESTPAT' and press ENTER.
7. Select from the screen the number for the color or text mode you want to
setup.
8. Select from the screen the number for the video mode you want to
setup.
You may repeat this process for as many of the color and video modes
as you need.
9. When the dot pattern appears, press the OSD Enter button
bottom of the monitor to display the initial OSD menu.
10. Use an Arrow button (
then press the OSD Enter
11. Using an Arrow button (
OSD Enter button
will optimize the display settings with the provided dot-patterns.
The screen will blink off several times and you may notice small
changes to the test pattern.
12. When finished, the OSD main menu returns. Press the Exit button
to exit from the OSD.
13. Press the ESCAPE key to exit the test pattern program.
14. Type 'Exit' at the command prompt to return to Windows.
If you use other operating systems, perform the appropriate
those systems, also: see
Auto Setup for Windows 3.1, Windows 95, Windows 98, Windows NT or
Windows 2000, Windows Me or Windows XP.
or ) to select the IMAGE LOCK icon
button to access the function.
or ), select
. This activates the
A
and press the
AUTOMATIC
procedure, which
S
UTO ETUP
A S
UTO ETUP
at the
for