Advertisement
1.
If the low battery alarm sounds, this means that the input voltage is below the
necessary 11 V. The battery needs recharging. You should stop using the
appliance and then recharge the battery. If this is not done, the Inverter will
shut off automatically at around 10 V.
2.
If you are unsure if the inverter will have the proper amount of current to run
the device, use this rough guideline: Take the power consumption of the load
in watts and divide it by 12 (input voltage). The result will be the approximate
number of amps needed to power your device.
Example: Load is rated at 312 watts. 312 watts / 12 V = 26 amps needed.
You could use this device with the inverter.
3.
If your television will not start, it is important to keep in mind that some appli-
ances (including many televisions) may require two to six times their wattage
to start up.
4.
If your audio system buzzes while using this inverter, it is because some
sound systems can not filter out the modified sine wave produced by the
inverter. Use a sound system that incorporates a higher quality power supply.
5.
This inverter is made to minimize the interference with TV signals. However,
especially with weak TV signals, some interference may still be visible. To
correct this, place the inverter as far away as possible from the television
antenna and it's cables. Next, adjust the orientation of the inverter to the
antenna cables and TV power cord to minimize the interference. Also use a
shielded antenna cable.
6.
If the low battery alarm is on all the time, try these corrective measures: Re-
charge battery if in poor condition. Next, check the battery connection. You
may need to clean the connectors.
7.
If you are getting a low output voltage, try reducing the load to minimize
watts. You may have overloaded the inverter. Reduce your load to 390
watts. Also, keep input voltage above 11 volts to maintain a constant flow of
power.
8.
If you are not getting any power output, turn the power switch Off and On
again, until the green power light comes on. Your devices may draw too
much power to operate them. The inverter may be in thermal shutdown. Let
it cool down and make sure there is adequate ventilation around the unit.
For technical questions, please call 1-800-444-3353.
SKU 92708
TroubleSHooTINg TIPS
Page 7
Advertisement
