Kenmore 970.4952 Series Use & Care Manual page 10

Oven Controls
To Set Add 1 Minute Feature
A
The key is used to set the Add 1 Minute feature. When
the key is pressed, 1 minute is added to the Timer feature if this
feature is already active. If the Minute Timer feature is not
A
active and the is pressed, the Timer feature will become
active and will begin counting down from 1 minute. For further
information on how to set the Minute Timer feature see To Set
the Minute Timer instructions above.
Setting the Oven Lockout
The controls the Oven Lockout feature. The Oven Lockout
feature automatically locks the oven door and prevents the oven
from being turned on. It does not disable the clock, Timer or the
interior oven lights. The ovens can be locked individually.
To activate the Oven lockout feature:
1. Press and hold for 3 seconds.
2. After 3 seconds, DOOR, LOCKED will flash and Loc will
appear in the display
Once the oven door is locked the DOOR and LOCKED indicator
will stop flashing and remain in the display. Allow 15 seconds for
the oven door to lock.
To reactivate normal oven operation by unlocking door:
1. Press and hold for 3 seconds. Loc will disappear from
the display. DOOR and LOCKED will flash in the display
until the door has completely unlocked and the oven will be
operational.
Setting Silent Control Operation
The Self-Clean and Delay Start keys control the Silent Control
operation feature. The Silent Control operation feature allows
the oven control to be operated without sounds or beeps
whenever necessary. If desired the control can be programmed
for silent operation and later returned to operating with all the
normal sounds and beeps.
To change from normal sound to silent operation:
1. Press and hold Delay Start for 7 seconds. The display will
show dashes and then change to bEEP ON in the display.
2. Press Self Clean to switch between normal sound operation
and silent mode (beep off).
Press to accept the change or press
change.
Note: The control will always beep at the end of a timer and will
beep when a set temperature has been reached, even if the
control is set to silent operation.
10
to reject the