Flash/Jack Unit, Speaker Unit - Canon PowerShot G3 Service Manual

CHAPTER 3. REPAIR INSTRUCTION
(1)-2
a
(1)-3
CAUTION
Be careful not
to drop the
SPEAKER BUSH.
(2)-1
SPEAKER BUSH
NOTE3 (Assembling)

2.2.11 FLASH/JACK UNIT, SPEAKER UNIT

(1) FLASH/JACK UNIT
1. Remove the MAIN/FLASH FPC.
2. Remove the cable of the BAT BOX UNIT and two cables of the FLASH/JACK UNIT.
3. Remove the three screws of a.
4. Remove the cable of the SPEAKER UNIT.
5. Remove the two screws of q.
6. Remove the two dowels and raise FLASH/JACK UNIT. Then push out the FLASH/JACK UNIT to the front
and remove the FLASH/JACK UNIT.
NOTE1 (Assembling)
Insert the cable coming from the BAT BOX UNIT to the red connector. Insert the cable coming from the
FLASH/JACK UNIT to the white connector.
(2) SPEAKER UNIT
1. Remove the SPEAKER BUSH.
2. Remove the SPEAKER UNIT from the FLASH/JACK UNIT.
CAUTION
Be careful not to drop the SPEAKER BUSH.
NOTE2 (Assembling)
Attach the double-sided adhesive tape at the position as shown in the illustration and install the SPEAKER
UNIT.
NOTE3 (Assembling)
Route the cable of the SPEAKER UNIT as shown in the illustration.
(1)-2
(1)-2
(1)-1
MAIN/FLASH
FPC
SPEAKER
UNIT
(2)-2
(1)-4
(2)-2
NOTE2 (Assembling)
Double-sided
adhesive tape
Fig. 3-14 FLASH/JACK UNIT, SPEAKER UNIT
NOTE-1 (Assembling)
FLASH/JACK UNIT
Red
DC/DC CONVERTER
White
PCB ASS'Y
FLASH/JACK UNIT
Dowels
(1)-6
(2)-2
CB1-1998-000
METAL
M1.7
3-14
(1)-2
(1)-5
q
a q
XA4-9170-359
3.5mm
3.0mm
BLACK
M1.7
(SELF TAP)