Bat Box Unit; Hv Module Unit, Slt Holder, Leaf Sw Unit, R/C Holder - Canon PowerShot G3 Service Manual

CHAPTER 3. REPAIR INSTRUCTION
BAT BOX SUB UNIT
(1)-2
CF CLIPPING1
SPRING
(1)-1
o
Dowels
NOTE2 (Assembling)
R/C HOLDER
Fig. 3-30 HV MODULE UNIT, SLT HOLDER, LEAF SW UNIT, R/C HOLDER

2.3.5 BAT BOX UNIT

2.3.5.1 HV MODULE UNIT, SLT HOLDER, LEAF SW UNIT, R/C HOLDER

(1) HV MODULE UNIT, SLT HOLDER, LEAF SW UNIT
1. Remove the screw of o.
2. Remove the CF CLIPPING1 SPRING.
3. Remove the screw of q.
4. Remove the LEAF SW COVER.
5. Remove the cable of the BAT BOX SUB UNIT.
6. Remove the three screws of q.
7. Remove the nine dowels, then remove the HV MODULE UNIT, SLT HOLDER and LEAF SW UNIT.
NOTE1 (Assembling)
When installing the HV MODULE UNIT, SLT HOLDER and LEAF SW UNIT, insert the flexible board of
the HV MODULE UNIT into the grooves of the R/C HOLDER (Two places).
(2) R/C HOLDER
1. Remove the screw of q.
2. Remove the R/C HOLDER.
NOTE2 (Assembling)
Route the cable of the BATTERY BOX SUB UNIT so that it passes the back side of the R/C HOLDER as
shown in the illustration.
q
(1)-6
(2)-2
R/C HOLDER
(1)-5
(2)-1
q
(2)-2
HV MODULE UNIT,
SLT HOLDER,
LEAF SW UNIT
3-30
NOTE1 (Assembling)
Insert the two places of the
flexible board into the grooves.
(1)-7
(1)-4
LEAF SW COVER
(1)-6
o
XA4-5170-307
METAL
M1.7
(SELF TAP)
(1)-7
(1)-3
q
q
q
XA4-9170-359
3.0mm 3.5mm
BLACK
M1.7
(SELF TAP)