Advertisement
NOTE: The electric fireplace heater may emit
a slight harmless odor when first turned
on. This is caused by activating the internal
heater components for the first time and
should not occur again.
IMpOrTANT
Please note, when you oPen the
carton carefully check the unit
and make sure there is no damage.
if you have any Problems with
assembling the unit, with how the
various functions work or with
damage or missing Parts Please
call 1-800-459-4409 (9am to 5Pm est)
immediately for service.
note: do not return unit to the
store before calling the toll
free number.
do not disPose of your cartons
until you are comPletely satisfied
with your new firePlace heater.
NOTE: light bulbs may become loose during
shipping. If the flame effect is dim or does not
work, please check that the light bulb or bulbs
are finger tight in socket. See instructions for
replacing the bulb or bulbs.
cAUTION: If you use this heater in conjunction
with a thermal control, a program controller,
a timer or any other device that switches
the heater on automatically, remember to
observe all safety warnings at all times.
The fireplace heater has safety overheat
protection. If the overheat protection trips,
switch off all switch buttons and wait
approximately 5 -10 minutes. It should reset
automatically once the unit cools down.
S A F E T Y I N S T r U c T I O N S
WArNING:
procedures and techniques, if not carefully
followed, will result in damage to the
equipment and will expose the user to the risk
of serious injury, illness or death.
This electric fireplace heater is for use on
120 volts. The cord has a plug as shown at A
in illustration below. An adapter as shown
at c is available for connecting three-blade
grounding-type plugs to two-slot receptacles.
The green grounding plug extending from the
adapter must be connected to a permanent
ground such as a properly grounded outlet
box. The adapter should not be used if a
three-slot grounded receptacle is available.
A 15 AMp circuit is required to operate this
heater. If the breaker trips when the heater is
used then you may need to move the heater to
another location or unplug other appliances
that are on the same circuit. If you require an
extension cord use one that is rated at 1875
watts.
3
Advertisement
