Full Specifications - DPA 4017 User Manual

FULL SPECIFICATIONS

Cartridge type
1 9 mm (0. 7 5 in) pre-polarized condenser
Principle of operation
Pressure gradient, supercardioid with interference tube
Power supply
48 V Phantom power
Frequency range; ±2 dB
70 Hz – 20 kHz, permanent third order high pass filter at 50 Hz
Switching filters
High boost, +4 dB at 8 kHz (shelving)
Bass roll-off, first order filter, below 300 Hz
Directional characteristics
Supercardioid, lobe-shaped shotgun
Sensitivity, nominal, ±2 dB
30 mV/Pa; -30 dB re. 1 V/Pa
Equivalent noise level A-weighted
Typ. 1 4 dB(A), (max. 1 5 dB(A))
Equivalent noise level ITU-R BS.468-4
Typ. 25 dB, (max. 26 dB)
Max. SPL, peak before clipping
1 32 dB
Total harmonic distortion
<0.5 % up to 1 30 dB SPL peak
<1 % up to 1 3 1 dB SPL peak
Output voltage
Max. 2.2 V peak
Output impedance
<200 ohm
Dynamic range
Typ. 1 1 7 dB
S/N ratio, re. 1 kHz at 1 Pa (94 dB SPL)
80 dB (A)
Connector
XLR-3M, Pin 1: Ground, Pin 2: Signal + phase, Pin 3: SIgnal - phase
Polarity
Positively increasing sound pressure creates positive going voltage on pin 2.
7