Accessing System Board Components And Drives - IBM 6826 Hardware Maintenance Manual

Accessing system board components and drives

To access some components on the system board such as memory, the battery, and
the Clear CMOS/BIOS recovery jumper, it may be necessary to slide the diskette
and CD drive tray outward to the front of the computer.
To access system board components or drives:
1. Turn off the computer.
2. Remove the cover. See "Removing the cover" on page 19.
3. Remove the screw securing the drive tray to the riser card support.
4. Press in on the drive tray buttons at each side as shown, and slide tray forward
5. Slide the drive tray to the front just far enough to access the necessary system
6. If any PCI adapters are installed, remove the PCI riser and adapter cards. Do
22
Hardware Maintenance Manual
to access drives.
Notes:
a. It may be necessary to disconnect some cables attached to the drives to
allow the drive tray to slide out far enough to access some system board
components. To remove the drive tray completely, disconnect all the cables
attached to the diskette and CD drives.
b. Make sure you note the location of any cables that you disconnect from the
drives.
board component.
not remove any adapters from the riser card.