Controlling The Camera - Lorex Vantage LZC7091 Instruction Manual

Controlling the PTZ Camera with your DVR
4. Configure the following:
• Channel: Select the channel the
camera is connected to.
• Protocol: Select the protocol
(default: Pelco-D).
• Baud rate: Select the camera's
baud rate (default: 2400).
• Data Bit: Select 8.
• Stop Bit: Select 1.
• Parity: Select None.
• Cruise: Select Enable to enable PTZ cruise.
• Address: Enter the camera's ID (default: 001).
5. Click Apply to save your settings.

4.2 CONTROLLING THE CAMERA

TIP: Turn off motion detection on your DVR for the channel with the PTZ
camera connected. Otherwise, the DVR will detect the PTZ movement as
motion. See your DVR's instruction manual for details.
To control the PTZ camera locally on the ECO2 DVR:
1. Select the channel that the PTZ camera is connected to.
2. Press and hold the PTZ button on the front panel of the system for 6
seconds.
• OR, Right-click with the mouse to open the Menu Bar and click the
PTZ button (
• Enter the DVR password (default: 000000) and click Apply.
16
).
PTZ button
Press & hold
6 seconds