Table of Contents
Advertisement
B . Appliance Ins pection - Routine
• F req uency: E very 2 months at the same time the chim-
ney and chimney connector are inspected.
•
H omeowner
C heck for:
• Cracks in glass
• Door handle - smooth cam operation
• Baffles are in correct placement
•
Baffle for warpage
• Firebrick for cracks, broken or crumbly
• Door gasket. (Dollar bill test). Place a dollar bill between
the stove and the door and then shut the door. If you can
pull the dollar bill out, replace the door gask e t.
• Glass frame for loose screws
C. Ins pect F ireb rick & Replacement
Ins tructions
•
After each ash removal
•
H omeowner
Replace the firebrick if they become crumbly and/or if there
is a 1 /4 inch ( 6 .3 5 mm) gap between the brick s .
The firebox is lined with firebrick, which has exceptional in-
sulating properties. Do not use a grate; simply build a fire on
the firebox floor. Do not operate appliance without firebrick.
Ensure that the firebricks are correctly positioned and that
the firebox does not contain any broken brick prior to operat-
ing the unit.
1. After the coals have completely cooled, remove all old
brick and ash from unit and vacuum out firebox.
2 . Remove new brick set from box and lay out to the
diagram shown in the instructions that come with the
replacement brick set
3. Lay bottom bricks in unit.
4 . Install rear brick s on the top of the bottom brick s . Slide
top of bricks under clip on back of firebox wall and push
bottom of brick s back .
5 . Install side brick s . Slide top of brick under clips on side
of firebox and push the bottom of the brick until it is flush
with the side of the unit.
Us e P art # 8 3 2 - 0 5 5 0
b rick . P rov ide b rick dimens ion or copy the page
in the Serv ice P arts Lis t s howing the b rick dia-
gram, mark the des ired b rick and tak e it to your
authoriz e d dealer.
M arch 2 1 , 2 0 1 3
Is le Royale Wood Stov e
when ordering indiv idual
D. G las s Replacement
1 .
Ensure that the fire is out and the appliance is cool
to the touch.
2 .
P rotect a table or counter top with padding or towels.
Protect your hands and wear gloves to prevent injury.
3 .
Remove the door with the brok e n glass by lifting the
door up and off of the hinges.
4 .
Lay door face down on a table or counter making sure
the handle and handle attachment k nob hangs over
the edge so the door lays flat on a soft surface.
5 .
Remove the screws from each glass retainer and
remove the glass. (If screws are difficult to remove,
soak with penetrating oil first).
6 .
C enter the glass with edges evenly overlapping the
opening in the door, ( i.e. same space top and bottom,
left and right sides) .
7 .
Replace the glass retainers. B e careful not to cross
thread the screws.
8.
Tighten each retainer just a few turns until each is
secured. C heck again for centering of glass in door
frame. C ontinue to tighten each retainer alternately,
a few turns at a time, until the glass is snug. DO NO T
O V E RT IG H T E N.
9 .
Replace the door on the appliance.
Q uadra - F ire stoves are e q uipped with ceramic super
heat- resistant glass, which can only be brok e n by impact
or misuse.
Do not slam stove door or impact the glass. W hen closing
door, ma k e sure that logs do not protrude against the
glass. Inspect glass regularly.
If you find a crack or break, immediately put the fire out
and return the door to your dealer for replacement of glass
before further use.
Glass
Assembly
• Do NOT operate with glass cracked, broken or scratched.
F ire Ris k .
Inj ury Ris k .
• Use only glass specified in manual.
• DO NOT REPLACE with any other material.
G lass break a ge will occur.
2 5 0 - 5 7 6 3 F
WARNING
Handle glas s with care.
• Inspect the gasket to ensure it is
undamaged.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass
& door assembly removed.
WARNING
R
P age 2 9
Advertisement
Table of Contents
