C O N T E N T S Drawing explanation Packaging Technical Specification Parts overview 1. IMPORTANT INFORMATION General warning and safety information Before setting up 2. BRIEF HEATING INFORMATION Suitable fuels and fuel quantities Fuel Quantities Maximum fuel quantity Clean burning Burning wood 3.
PACKAGING The owner of small firing systems or the person authorised for the small firing system is to keep the Your first impression is important to us! technical documentation and is to submit it to the The packaging of your new stove provides excellent pro- authorities or the chimney sweep on request.
I M P O R T A N T I N F O R M A T I O N GENERAL WARNING AND PRIOR TO SET-UP SAFETY INFORMATION 1.1 Ground load bearing capacity: The general introductory warning information must be Before setting up, ensure that the supporting construction followed.
Page 9
1.2 Flue pipe connection Flue pipes are a particular hazard source in respect of The fire door must only be opened for adding fuel and must then be closed again, as this could otherwise lead to escape of poisonous gas and fire hazard. Obtain the ad- a danger to other fires that are also connected to the vice of an appointed specialist company in respect of chimney.
B R I E F H E A T I N G I N F O R M A T I O N SUITABLE FUELS AND FUELS MAXIMUM FUEL QUANTITIES QUANTITIES Wood: 2 logs of approx. 0.6 kg In principle your fire is suitable for burning dry billets. You can also burn fuels such as wood brickets.
2. THE RIGHT QUANTITY OF FIREWOOD The challenges of the present day and age mean that AND FIREWOOD DIMENSIONS everyone must act responsibly. One of most important matters of concern is retaining our natural world. Our products are developments that comply with the most - Too much firewood leads to overheating.
Part 47 and 31) is in the correct position. When using a flue pipe with throttle valve, the throttle We recommend original flue pipes from RIKA for proper valve must be open. connection.
4. OPERATION STARTING THE FIRE (Illustrated: Safety clearances) After this has burned, lay approx 1.3 kg wood (2 billets) on In order to keep exhaust emissions as low as possible, we the fire. Open the shaker grate handle and the primary air would ask you to keep to the following starting instructions.
THE FIRE PAINT ONLY HARDENS PROPERLY AFTER OPERATING THE SHAKER GRATE HEATING UP DURING USE. (Page 4, Part 27) Do not touch the surface during heating. It is still soft. The ash is moved from the fire into the ash drawer by moving the shaker grate handle to and fro.
5. FITTING OPTIONS CHANGING FLUE PIPE CONNEC- TION ABOVE TO CONNECTION AT REAR (Page 4) - Swap the flue gas connector and the hob (part 51, 53) - Remove the both natural stone covers (part 40 and with each other. 41).
Only intact seals guarantee the perfect function of your fire. FINISH – CONDITION AND CLEAN- The door glass can be cleaned using RIKA glass cleaner. The RIKA glass cleaner can be obtained from your special- ist fire dealer. Should the glass become heavily sooted the possible cause could be damp wood.
WHAT TO DO IF… Problem Reason Solution Always: Every glass plate must be cleaned from 1. Ceramic glass soots over too time to time (depending on use) with RIKA glass quickly cleaner Clarification with chimney sweep (possible raising Poor air movement of chimney)