Overview of technical data and spare parts 1. I M P O R TA N T I N F O R M AT I O N General warning and safety instructions Before installing the appliance 20 - 21 INFORMATION ON HEATING PRACTICE Suitable fuels and quantities Fuel quantities Maximum fuel quantities...
Page 7
TECHNICAL DATA Dimensions (mm) and weights (kg) Height Width Depth of the corpus Weight with steel casing Weight with stone casing Smoke flue outlet diameter Nominal heating power (DIN 18891) 7 kW Lowest heating power 3,5 kW Space heating capacity (m³) – 70-190 dependent on house insulation Fuel flow...
1 . I M P O R T A N T I N F O R M A T I O N GENERAL WARNING AND The placing of non-heat resistant objects SAFETY INSTRUCTIONS on or near the heating appliance is prohi- bited.
Page 9
1 . 7 1 . 3 Be sure to note the build-up of flue gases When opening the doors on your appliance under unfavourable weather conditions and when actuating the controls, use the tools provided with your heater for these (Weather inversion) and the flue draft behaviour.
I N F O R M A T I O N O N H E A T I N G P R A C T I C E SUITABLE FUELS AND QUANTITIES MAXIMUM FUEL QUANTITIES Your appliance is basically suitable for Wood: (Fig.
Satisfying the challenges of our time 2. THE CORRECT QUANTITY AND SIZES OF WOOD FUEL implies the acceptance of responsibility. The conservation of nature is now one of Too much wood fuel results in overhea- our greatest challenges. Our products are ting.
3 . O P E R A T I O N FIRING UP (Fig. 12) Now ignite the paper. Wait until the soft- In order to suppress the emission of pollu- wood chippings are burning well. tants as far as possible, we would ask you - Several minutes later, close the vibrating for the sake of the environment - to adhere grate actuator and the primary air damper.
THE ENAMEL APPLIED TO YOUR HEATING Caution: Burning embers can still be present APPLIANCE BECOMES FULLY HARDENED in the ash. Therefore only empty the ash into THROUGH HEATING DURING INITIAL USE. a non-flammable container and do not place the ash drawer on flammable surfaces. - Do not touch the surface during initial heating.
The black surface of the appliance is highly GENERAL MAINTENANCE heat-resistant and need only be cleaned Your ALPHA II appliance has been designed using a cloth (dampened if necessary). If by our development team with the the surface needs to be restored, then use...
T R O U B L E S H O O T I N G What to do if ...? Problem Reason Solution Basically: From time to time (depen- 1. Ceramic glass pane soots up ding on usage), each glass too quickly pane must be cleaned using a special glass cleaner (e.g.
Page 17
RIKA dealer in writing using the temperature controller. Damage arising from non- invoice and stating the purchase date, model name, observance of the manufacturer’s instructions for serial number and reason for complaint.
Need help?
Do you have a question about the ALPHA II and is the answer not in the manual?
Questions and answers