Parental Setup; Auto Upgrade; Searching For New Software; Using The System Information - Toshiba 55WL800AZ Owner's Manual

Parental Setup

The Parental Control feature allows you to block
programmes according to their rating levels� If a PIN has
been set, you will need to enter it before adjusting the
level�
1
From the DTV Settings menu, press s or r to
select Parental Control �
Parental Control
Parental Setup
Playback Setup
2
Press v or w to choose the desired Parental Setup
option�
• None, Block all, Block G and above, Block
PGR and above, Block AO and above�
To view blocked programmes, enter the PIN�
Playback Setup : Use for the playback mode (if record)�
• Enabled , Disabled and Every Time

Using the System Information

This feature can be used to check the version of software
currently installed� When in DTV mode, it includes
additional diagnostic information such as signal strength,
signal quality, centre frequency, modulation, etc�
1
From the System Setup menu, press s or r until
System Information is selected�
2
Press OK to display the System Information �
System Information
x.x.x.x Xxx xx 2011 - xx:xx:xx XX:xx
WEAK
Ch22
Ch25
Ch35
Ch46
3
For information about the signal quality of a particular
multiplex, press s or r to select that multiplex�
4
Press OK for a screen showing detailed technical
information about the selected multiplex�
46
Other Digital TV features and settings
None
Enabled
TOSHIBA
2011
AVERAGE STRONG
Poor
Good
Good
Good

Local Time Settings

• This function allows you to manually set the time.
Please note that if you manually change the time
setting, all existing entries under Programme Timers
will become invalid as they are still based on the old
time� It is recommended that you delete all entries under
Programme Timers before proceeding with the steps
described below�
1
From the DTV Settings menu, press s or r to
select Local Time Setting �
2
Press OK and press v or w to set as required�
Local Time Setting
Local Time

Performing a Software Upgrade

Auto Upgrade

When Auto Upgrade is set to On , the television will
automatically upgrade while in standby if new software is
available�
1
From the System Setup menu, press s or r to
select Software Upgrade and press OK �
2
Press s or r to select Over-the-air Upgrade and
press OK �
3
Press s or r to select Auto Upgrade �
4
Use v or w to select On or Off �

Searching for New Software

If preferred, software upgrades can be searched for
manually using Search for New Software �
1
From the System Setup menu, press s or r to
select Software Upgrade and press OK �
2
Press s or r to select Over-the-air Upgrade and
press OK �
3
Press s or r to select Search for New Software �
4
Press OK � The television will automatically start
searching for a software upgrade, the progress bar will
move along the line�
SEARCHING FOR NEW SOFTWARE
Searching for a new software upgrade for this TV.
Searching
If an upgrade is found, the television will
automatically start downloading� If not, a screen will
appear stating that an upgrade is unavailable�
11:30