Kyocera FS-1040 Operation Manual page 55

Symptom
Vapor is emitted near the
top tray.
Full black printout or faint
printing.
Paper often jams.
2 or more sheets are
overlaps when ejected.
(multi feed)
Printouts are wrinkled.
Checkpoints
Check if the temperature is low near
the location of the printer, or if the
paper that is being used has been
exposed to humidity.
—
Is the paper loaded correctly?
Is the paper of the supported type? Is
it in good condition?
Is the paper curled, folded or wrinkled? Replace the paper with new paper.
Are there any loose scraps or jammed
paper in the printer?
—
Is the paper damp?
Corrective Actions
Depending on the operating
environment of the printer and the
condition of the paper, heat generated
during printing can evaporate water
moisture in the printed paper, emitting
vapor from the printer. In this case,
printing can be continued without any
problem.
To correct this, increase the
temperature in the room, and use
paper that has been stored in a dry
place.
Open the rear cover and press the
points shown in the figure. If the
problem is not solved even after
printing several pages, call for service.
Load the paper correctly.
Remove the paper, turn it over, and
reload it.
Remove any jammed paper.
Load the paper correctly.
Replace the paper with new paper.
5-3
Troubleshooting
Reference
Page
—
—
3-10, 3-13
3-1
3-1
5-8
3-10
3-1