Table of Contents
Advertisement
General Information
This chapter describes basic maintenance tasks you can perform for the printer. You can replace the toner container
according to the printer's status:
Also, the internal parts need periodic cleaning.
Note Information Collection on Memory Chips - The memory chip attached to the toner container is designed to
improve convenience for the end user; to support the recycling operation of empty toner containers; and to gather
information to support new product planning and development. The information gathered is anonymous - it cannot
be associated to any specific individual and the data is intended to be used anonymously.
Toner Container Replacement
The Attention indicator identifies the toner status at two stages of toner usage.
•
When the printer becomes low on toner, the Attention indicator flashes and a message appears in the KYOCERA
Client Tool. Note the replacement is not always necessary at this stage.
•
If you ignore the above status and continue printing, the Attention indicator will light up just before the toner is used up
and the printer will stop. The toner container must then be replaced immediately.
In either case, replace the toner container.
Note If Non-genuine Toner is installed appears in the KYOCERA Client Tool after the toner container is replaced,
the installed toner container is non-genuine.
The manufacturer assumes no responsibility for damage caused by a non-genuine toner.
We recommend that you only use genuine toner containers.
When you want to use the toner container currently installed, press [GO] and [Cancel] simultaneously for 3
seconds or more.
Frequency of toner container replacement
According to ISO 19752 and EcoPrint switched off the toner container can print as follows (A4/Letter paper is assumed):
2,500 pages (FS-1040), 1,600 pages (FS-1041), 3,000 pages (FS-1060DN) or 2,100 pages (FS-1061DN).
You can print a status page to check how much toner remains in the toner container. The Toner Gauge in the consumables
status section on the status page shows a progress bar, which roughly represents how much toner is left in the toner
container.
Starter Toner Container
The toner container packed with the new printer is a starter toner container. The starter toner container lasts an average of
700 pages (FS-1040/FS-1041) or 1,000 pages (FS-1060DN/FS-1061DN).
Toner Kits
For best results, we recommend that you only use genuine Kyocera Parts and Supplies. Should any damage be caused by
the application of a toner other than the original toner, then this damage is excluded from the guarantee.
A new toner kit contains the following items:
•
Toner Container
•
Plastic waste bag for old toner container
•
Installation Guide
Note Do not remove the toner container from the carton until you are ready to install it in the printer.
4-2
Maintenance
Hide quick links:
Advertisement
Table of Contents
