Surface And Pillow Care And Cleaning - Strong Monaco 20 Owner's Manual

Cleaning and Care Instructions for
Resin and Acrylic Spa Surfaces
For normal care and cleaning, use a soft cloth or sponge with soap and
water. Rinse well and dry with a soft, clean cloth. Before using any house-
hold cleaner on an acrylic surface, make sure it is recommended for use on
acrylic by the manufacturer.
• Remove dust and dry dirt with a soft, clean, damp cloth.
• Clean grease, oil, paint and ink stains with isopropyl (rubbing) alcohol.
Rinse well and dry with a soft, clean cloth.
• Never use abrasive cleaners.
• Do not allow your surface to come into contact with nail polish, nail pol-
ish remover, wintergreen oil (methyl salicylate), dry cleaning solution,
lacquer thinners, gasoline, pine oil, etc.
• Avoid placing razorblades or other sharp instruments on this surface as
they may scratch it. Small scratches can be removed by buffing lightly
with a clean cloth and using either an automotive polishing liquid or a
toothpaste containing a fine polishing ingredient. For deeper scratches,
sand the surface lightly with 400 grit "wet or dry" paper and buff with
fine-grit buffing compound.
Cleaning and Care Instructions for Spa Pillows
attachment and removal
Suction Cup:
To attach - Moisten surface of suction cup and apply pillow to surface.
To remove - Place finger on edge of suction cup to break suction and
lift away.
Pin mount receptacle:
To attach - Insert ball pin into receptacle in spa wall.
To remove - Gently pull pillow ball pin out of receptacle (if ball pin is
pulled out of receptacle in pillow, it can be reinserted)
Cleaning and Care
Pillows can be cleaned with soap and water, mild household cleaners.
Air Inflating
A standard ball needle valve can be used to adjust the air filled comfort
of the pillow. Gently insert the needle adapter into the the valve to
inflate/deflate.
WarninG: onlY use a Hand Held air PumP or manuallY inflaTe usinG THe needle
adaPTor - do noT use ComPressed air and never inflaTe over 1 Psi.
As of April 1st, 2008 Strong Spas will beg
converting the pillows in the Syberian Ser
Spas to in atable pillows.
To see if you have an in atable pillow
remove the pillow and look for the
in ation point on the back of the pillow
The pillows can be in ated using a
standard pump and in ating needle.
NOTICE
27