Strong Monaco 20 Owner's Manual page 25

Problem:
could indicate a flow problem.
Solution:
the pumps have been primed. If problem persists, contact your dealer or service organiza-
tion.
Problem:
message within 24 hours.) Heater is shut down, but other spa functions continue to run
normally.
Solution:
reset automatically; you may press any button to reset.
Problem:
Spa is shut down for 15 minutes.
Solution:
the pumps have been primed. Press any button to reset, or this message will automatically
reset within 15 minutes. If problem persists, contact your dealer or service organization.
Problem:
sage) Spa is shut down.
Solution:
any button to reset.
On a fresh fill your pump may be air locked, refer to page #18 for removing an air lock.
WARNING! SHOCK HAZARD! NO USER SERVICEABLE PARTS.
Do not attempt to service the control system. Contact your dealer or ser-
vice organization for assistance. Follow all owner's manual power con-
nection instructions. Installation must be performed by a licensed electri-
cian and all grounding connections must be properly installed.
A significant difference between temperature sensors has been detected. This
Check water level in spa. Refill if necessary. If the water level is okay, make sure
Persistent low flow problems. (Displays on the fifth occurrence of "HFL"
Follow action required for "HFL" message. Heating capability of the spa will not
Possible inadequate water, poor flow, or air bubbles in detected in the heater.
Check water level in spa. Refill if necessary. If water level is okay, make sure
Inadequate water detected in heater. (Displays on third occurrence of "dr" mes-
Follow action required for "dr" message. Spa will not automatically reset. Press
25