Control Pack Codes - Strong Monaco 20 Owner's Manual

Acrylic spas
Table of Contents

Advertisement

(Monaco 20 & 31, Seville 22, El Dorado 22 and Barcelona 33 Only)
22

CONTROL PACK CODES

Problem:
No message on display. Power has been cut off to spa.
solution:
The control panel will be disabled until power returns. Or .3 amp fuse is
blown and needs to be replaced.
Problem:
Temperature unknown.
solution:
After the pump has been running for 2 minutes, the temperature will be
displayed.
Problem:
"Overheat" - The spa has shut down. One of the sensors has detected that
110ºF/43ºC at the heater.
solution:
do noT enTer THe WaTer. Remove the spa cover and allow water
to cool. Once the heater has cooled reset by pushing any button. If spa does not reset,
shut off the power to the spa and call your dealer or service organization.
Problem:
"Overheat" - The spa has shut down. One of the sensors has detected that
the spa water is 110ºF/43ºC.
solution:
do noT enTer THe WaTer. Remove the spa cover and allow water
to cool. At 107ºF/42ºC, the spa should automatically reset. If spa does not reset, shut
off the power to the spa and call your dealer or service organization.
Problem:
"Ice" - Potential freeze condition detected.
solution:
No action required. The pump and blower will automatically activate re-
gardless of spa status. See page 15.
Problem:
Spa is shut down. The sensor that is plugged into the Sensor "A" jack is
not working.
solution:
If the problem persists, contact your dealer or service organization. (May
appear temporarily in an overheat situation and disappear when the heater cools.)
Problem:
Spa is shut down. The sensor that is plugged into the Sensor "B" jack is
not working.
solution:
If the problem persists, contact your dealer or service organization. (May
appear temporarily in an overheat situation and disappear when the heater cools.)
Problem:
Sensors are out of balance. If alternating with spa temperature, it may just
be a temporary condition. If flashing by itself, spa is shut down.
solution:
If the problem persists, contact your dealer or service organization.

Advertisement

Table of Contents
loading

Table of Contents