Honda CR-V Installation Instructions Manual page 6

NOTE: If another accessory is already plugged into the
1-pin connector: Connect the 1-pin connector from the
other accessory harness into the 1-pin connector taped
to the security harness, then connect the 1-pin
connector from the security harness into the fuse box.
ANOTHER
ACCESSORY
HARNESS
20. Reinstall the upper column cover; then, route the
LED harness along the vehicle harness.
UPPER COLUMN
COVER
2-PIN
CONNECTOR
21. Connect the LED harness 2-pin connector to the
security harness 2-pin connector, and wrap one
cushion tape around the 2-pin connectors.
22. Reinstall the lower column cover.
6 of 6
SECURITY
HARNESS
1-PIN
CONNECTOR
LED
HARNESS
CUSHION TAPE
AII 27188 (0409)
23. Route the microphone cord along the security
harness, and plug the microphone jack into the
security unit. Secure the microphone cord to the
vehicle harness with the one wire tie.
SECURITY
MICROPHONE
HARNESS
CORD
WIRE
TIE
SECURITY
UNIT
WIRE
MICROPHONE
TIE
JACK
24. Secure the security harness and microphone cord
to the vehicle harness with three wire ties in the
area shown.
25. Check that all wire harnesses are routed properly
and all connectors are plugged in.
26. Reinstall all removed parts.
27. Reconnect the negative cable to the battery.
28. Enter the customer's radio anti-theft code, and
reset the radio station presets.
29. Reset the clock.
30. Check operation of the security system according
to the Security System owner's manual supplied.
NOTE: Whenever the battery is disconnected, the
driver's window AUTO function is disabled.
31. Start the engine. Push down on the driver's
window switch until the window is fully open.
32. Pull up on the driver's window switch fully to close
the window completely, then hold the switch for
2 seconds or more.
33. Test the driver's window AUTO function.
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
WIRE TIE
WIRE
TIE
VEHICLE
HARNESS
SECURITY
HARNESS
MICROPHONE
CORD