Honda CR-V Installation Instructions Manual page 3

6. Measure and mark the upper steering column
cover.
PUNCH
UPPER STEERING
COLUMN COVER
7. While wearing eye protection, lightly center-punch
the mark, and drill a 5.5 mm hole through the
upper steering column cover. Remove all burrs.
8. Route the terminal ends of the LED through the
hole you just drilled, and secure the LED with the
push nut. Using isopropyl alcohol, clean the area
where the half of the cushion tape will attach.
Secure the harness of the LED to the back of the
upper column cover with half of a cushion tape.
PUSH
NUT
HALF OF
CUSHION TAPE
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
DRILL
5.5 mm bit
FELT-TIP PEN
40 mm
UPPER STEERING
COLUMN COVER
Cut off
CUSHION
TAPE
9. Locate the 2-pin connector from the kit. Firmly
push the LED terminals into the 2-pin connector,
and lower the lock.
NOTE: If the wires are not correctly installed in the
connector, the LED will not work.
2-PIN
CONNECTOR
10. Measure and mark the driver's dashboard lower
cover.
50 mm
DRIVER'S
DASHBOARD
LOWER COVER
11. While wearing eye protection, lightly center-punch
the mark, and drill an 8 mm hole through the
center-punched mark, Remove all burrs.
• First drill a pilot hole with a 3 mm drill bit, then
finish with an 8 mm drill bit.
AII 27188 (0409)
LOCK
WHITE WIRE
RED WIRE
20 mm
CLIP
DRILL
FELT-TIP
PEN
8 mm
DRILL
BIT
4610050M
3 of 6