Illustration Of Security System; Installation - Honda CR-V Installation Instructions Manual

Illustration of the Security System Installed on the
Vehicle
SECURITY
UNIT

INSTALLATION

Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures
should not be attempted by "do-it-yourselfers."
1. Make sure you have the anti-theft code for the
radio, then write down the radio station presets.
2. Disconnect the negative cable from the battery.
3. Remove the driver's dashboard under cover by
turning the knob clockwise, and releasing one
clip.
HOLDER
CLIP
2 of 6
LED
FUSE
MICROPHONE
CASE
KNOB
Turn
clockwise
DRIVER'S
90°.
DASHBOARD
UNDER COVER
4. Remove the driver's dashboard lower cover:
• Remove the fuse box lid, and open the pocket.
• Remove the two self-tapping screws.
• Gently pull out on the driver's dashboard lower
cover to release the eight clips. If equipped,
unplug the vehicle connector and remove the
lower cover.
VEHICLE
CONNECTOR
(If equipped.)
POCKET
5. Lower the steering wheel tilt lever. Remove the
upper and lower steering column covers. (two
self-tapping screws, one screw, and six tabs).
Gently push on the six retaining tabs, and
separate the two steering column covers.
UPPER
STEERING
COLUMN
COVER
Push
AII 27188 (0409)
SELF-
TAPPING
SCREW
CLIPS (8)
SCREW
TABS (6)
2904170M
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
VEHICLE
CONNECTOR
(If equipped.)
DRIVER'S
DASHBOARD
LOWER
COVER
HOOKS (2)
FUSE
BOX
LID
RETAINING
TABS (2)
CLIP
4130110H
LOWER
STEERING
COLUMN
COVER
SELF-
TAPPING
SCREW