Advertisement
LED Status In di ca tor
Select a prominent location on the motorcycle that is highly visible
from all directions. Discuss placement with the owner.
1. Verify there is adequate space to accommodate the LED, then
drill a 4mm (#21 drill bit) hole and route the wires through it.
2. Mate the BLACK wire connector labeled LED (+) to the LED's
VIOLET wire as shown in the diagram on page 5.
3. Mate the BLACK wire labeled LED (-) to the LED's BLACK
wire as shown in the diagram on page 5.
4. Press the LED into place.
Plain View 2 Coded Pro gram ming Switch
1. Discuss placement of the switch with the vehicle owner and
avoid placing the switch where it can be pressed accidentally.
2. Mount the switch on to a clean, dry surface using the supplied
adhesive tape.
3. Mate the switch's locking connectors to the locking connector from
the control unit.
4
GP500
Advertisement
