Advertisement
Fi nal Wir ing Con nec tions
1. Connect the BLACK wire labeled Constant +12V 5A to the 5-amp
fuseholder as shown on page 5.
2. Connect the BLACK wire labeled Constant +12V 10A to the
10-amp fuseholder as shown on page 5.
3. Attach the two fuseholders to the constant +12V source at the
fuse panel, battery or ignition harness.
4. Use ring connectors to attach the two different BLACK wireloom
wires (labeled ground) to two different chassis ground points or
one of them directly to the vehicle fuse panel ground. The
ground points must be very clean. A factory bolt that has been
completely cleaned with a wire brush is recommended.
NOTE: Power and test ac ces so ries af ter the ba sic
sys tem has been tested. In di vidu ally fuse all
ac ces sory power con nec tions. In di vidu ally fuse all
+12V fuse panel con nec tions.
In stal la tion Man ual/499
9
Advertisement
