Kreepy krauly SandShark Installation And User Manual page 17

12
Disassembly
1. With a screwdriver, carefully work the rubber vacuum pad down over the
lip of the Outer Housing, (see Figure 33).
2. Lift the Outer Housing straight up off of the chassis, (see Figure 34).
3. Squeeze and pull the Sprocket Clips to release the Drive Shaft Assembly
and Center Sprocket, (see Figure 35).
4. Pull the Oscillator Straight out from the bottom of the Outer Housing.
Be careful not to lose the Sliding Seals, (see Figure 36).
5. Squeeze the latching tabs and pull up on the Swivel Housing and Swivel.
The assembly will come up, releasing the Swivel Sprocket. Squeeze the
latching tabs to remove the Clutch Clip, (see Figure 37).
6. Remove the Shaft Plug with the stainless steel shaft and the Large
Steering Drive Assembly, (see Figure 38).
7. Remove the Oscillator Sleeve, releasing the Oscillator Sleeve Bushing
and the Clutch assembly, (see Figure 39).
8. If you need to replace the bumper, turn the housing/bumper assembly upside
down and remove the two flex snaps holding the bumper to the housing, (see
Figures 40 & 41). Use a piece of ½ in. (inside diameter) PVC pipe to slide
over the flex snap ends to squeeze the flex snaps together so they can be slid
out of the housing. Use a pair of pliers to
pop the flex snaps off of the bumper.
Reassembly
To reassemble the SandShark
steps above.
NOTE: The notch on the center disk of the
Large Steering Drive Assembly must be down,
(as shown in Figure 42), for assembly.
Figure 42.
™
SandShark Installation and User's Guide
™ , reverse the
Figure 41.
Figure 40.
Figure 39.
Figure 33.
Figure 34.
Use a pair of Pliers to pull the
Flex Snaps from the Bumper
Figure 35.
Figure 36.
Use a piece of ½ in.
PVC pipe (inside diameter)
to push the Flex Snaps
out of the Housing
Figure 37.
Figure 38.