Table of Contents
Advertisement
АМM-1130
(1) V/Ω/℃/CAP/DIODE/Hz end
It is the input end for all measurement functions except for current measurement, connected with a red meter probe.
(2) COM end
It is the negative input end for all measurements, connected with a black meter probe.
(3)µA/mA end
It is the positive end for measurement of µA or mA current, connected with a red meter probe.
(4)A end
It is the positive input end for measurement of 0.22A-10A current, connected with a red meter probe.
(5)Rotary switch
Used for selecting measurement functions such as Power off, voltage, current, resistance, temperature and Capacitance.
(6)PC-link switch
Used for connect PC for record the measurement value.
(7)PEAK-H key
Used for measuring PEAK-max, PEAK-min when input AC signal.
(8)HOLD key
Used to maintain the measurement data unchanging, by pressing the key again it will resume the measurement. Pressing this
key and last for 2 seconds, the meter will delay for 6 seconds, than enters HOLD mode.
8
Advertisement
Table of Contents
