Aktakom ??M-1130 User Manual page 5

АМM-1130
potential during measuring. Keep the body should be kept insulated from ground with dry insulating shoes, insulating pads
or insulating clothes.

When measurement with a test probe your fingers should be put behind a finger-protector.

Don't try to measure a voltage higher than 1000VAC or 1000VDC, the meter may be damaged and the operator's safety
may be threatened if the limit for voltage measurement is exceeded.

When the symbol of electric insufficiency appearing on the display screen it is necessary to replace the batteries for
avoiding the possible shock or injure resulted in by erroneous reading.

In case of replacing batteries, it is necessary firstly to pull out the testing line. AAA batteries should be used and they
should be put into the meter with the proper polarity.

Don't make any voltage measurement when the testing line being inserting into the current hole.

The repair and calibration of the meter must be carried out by experienced professionals, others should not repair and
calibrate the meter by themselves.
Limited Guarantee and the Liability Scope
The company will undertake to repair freely any quality problem of the meter within 18 months from the date when it was
bought, except for the replacement of fuse and batteries as well as any damage caused by negligence, wrong use, pollution,
change of circuit and non-normal use.
Please offer the invoice before maintenance. for the maintenance beyond the 18-month guarantee period, the company will
charge some repair fee and materials cost.
5