Wireless Settings Page (Mvp-5150 Only) - AMX Modero MVP-5150 Operation/Reference Manual

Wireless Settings Page (MVP-5150 Only)

Use the options on the Wireless Settings page (FIG. 54) to configure communication settings for the
wireless CF card (802.11b/g), and read the device number assigned to the panel.
Since the MVP-5100 does not have wireless capability, the button to this page is
greyed out in the MVP-5100 Protected Settings page.
FIG. 54 Wireless Settings page (reads from and assigns values to the WAP)
Features on this page include:
Wireless Settings Page
Back:
Connection Status icon:
IP Settings:
DHCP/STATIC
IP Address
Subnet Mask
Gateway
Host Name
Primary DNS
MVP-5100/5150 Modero Viewpoint Touch Panels
Saves all changes and returns to the previous page.
The icon in the upper-right corner of each Protected Setup page provides a
constant visual indication of current connection status.
Note: a Lock appears on the icon if the panel is connected to a secured NetLinx
Master.
Sets the IP communication values for the panel:
Sets the panel to either DHCP or Static communication modes.
• DHCP - a temporary IP Addresses is assigned to the panel by a DHCP
server. If DHCP is selected, the other IP Settings fields are disabled (see
below).
• Static IP is a permanent IP Address assigned to the panel. If Static IP is
selected, the other IP Settings fields are enabled (see below).
Enter the secondary IP address for this panel.
Enter the subnetwork address for this panel.
Enter the gateway address for this panel.
Enter the host name for this panel.
Enter the address of the primary DNS server used by this panel for host name
lookups.
Protected Setup Pages
61