Advertisement
10
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet box.
13
Loosen one and remove one pre-
assembled screw from mounting
bracket. Save screw. Lift canopy up,
aligning its keyhole slot with the pre-
assembled screw on mounting
bracket and twist clockwise to lock in
place. Re-install the removed screw
and tighten all screws securely.
16
Attach blade assembly to motor
using the motor screws and washers
provided. Tighten screws securely.
© 2011 Monte Carlo Fan Company
11
House
Black
White
Green
For pullchain controls, follow diagram above.
Make sure that all exposed wiring is secured
inside wire nuts. Note: Wires from house may
vary in color and may not include ground wire.
After wiring is conplete, gently push wires into
junction box with wire nuts pointing upward.
Refer to point 3 of safety tips.
14
Install 3 screws and washers per
blade and tighten securely. Repeat
for all 5 blades
17
After installation of all blades you
must replace the rubber grommet to
ensure no water leakage through to
switch housing.
4
12
Fan
Black
Blue
White
Green(downrod)
Green(Bracket)
For control of fan and optional light
from wall location, follow diagram
above. NOTE: A professional electri-
cian is recommended for this type of
installation.
15
Check the motor for plastic shipping
stabilizer tabs, and remove them if
they are present.
18
Black capacitor box needs to be
stuck to the switch housing. Not
being attached can cause motor
noise.
Wall
Control
2/3/2012
Advertisement
