Exerpeutic Inversion Table Owner's Manual page 17

For added convenience and safety, a set of Handlebars (6) has been added to the
inversion table. These Handlebars (6) are located at the top of the Rear Frame
(8). The Handlebars (6) are there to help you return to the upright position from
any degree of inversion. If you wish to return to the upright position, and the
backrest is moving too slowly, or not moving at all, simply grab the Handlebars (6)
and pull on them until you return to the upright position.
NOTE: The inversion table should always return to the upright position when you
move your hands below your waist. If it does not, the inversion table is probably
not adjusted correctly to your height.
* Always hold on to the handlebars and go back slowly. Failure to comply could
result in serious physical injury.
1. It is recommended that someone be with you while you are using this
inversion table for the first few times.
2. Make sure that the Front and Rear Rubber Heel Holders (13, 14) are holding
your feet securely.
3. Make sure that the Adjustable Boom (3) is properly set to your height.
4. Make sure that the Adjustable Boom (3) is held securely by the Adjustable
Boom Knob (41).
5. Make sure that there is enough room for the inversion table to rotate
completely.
OPERATION AND
ADJUSTMENTS
THE HANDLEBARS
GENERAL PRECAUTIONS
16