Exerpeutic Inversion Table Owner's Manual page 12

ASSEMBLY
Step 4:
Pull up on the Adjustable Instep Frame Knob (40), slide the Adjustable Instep
Frame (5) completely out of the Adjustable Boom (3) and then turn the Adjustable
Instep Frame (5) with the adjustable holes facing up. Release the Adjustable
Instep Frame Knob (40) and adjust the Adjustable Instep Frame (5) slightly until
the Adjustable Instep Frame Knob (40) locks into place.
Tool:
2 Wrenches (#13 & #17)
Step 5:
Slide the Foot Bar (4) into the bottom of the Adjustable Boom (3) and align the
hole on the Foot Bar (4) with the hole on the Adjustable Boom (3). Secure the
Foot Bar (4) in place using one M10x42mm Hexagon Head Bolt (46), one
Ø18xØ10.5x2.0 Flat Washer (47), and M10 Nylon Nut (48).
Hardware:
(47) Flat Washer
(46) Hexagon Head Bolt (48) Nylon Nut M10
Ø18xØ10.5x2.0
M10x42mm 1 PC
1 PC
1 PC
11