Electrolux EVE611SA User Manual page 62

62 installation
INSTALLATION OF THE APPLIANCE
Underbench oven
Your underbench oven looks best when the control panel
is directly under the benchtop. An upper infill panel may
be added if the cooktop placed above the benchtop is too
deep. Refer to cooktop installation instructions for required
clearance between cooktop and oven.
Cut-out dimensions
type of fit A (width)
Flush fit (mm)
Proud fit (mm)
Pyrolytic underbench cut-out dimensions
type of fit A (width) B (height)
Flush fit (mm) 600
Proud fit (mm) 568
1.5m electrical service
cord on EVEP615SA,
EVEP618BA
Note: Dimension 'D'.
For proper ventilation there must be a gap at the bottom
rear of the cabinet. This can be a slot 20mm deep or an
equivalent, full width opening (e.g. a series of holes) with
a min area of 120cm . The opening must be clear of the
2
product when fully installed. This is a requirement any
EVEPxxxxx model.
Power point connection for the EVEP615SA and
EVEP618BA must be accessible with the appliance fully
installed. If the supply cord is damaged it must be replaced
by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
B (height) C (depth)
600 600 581 min.
568 590 560 min.
561mm
596mm
C (depth)
600 581 min.
590 560 min.
561mm
596mm
Duo oven Cut-out dimensions
type of fit
Flush fit (mm)
Proud fit (mm)
650mm
min.
mounting
holes 582mm
Double oven Cut-out dimensions
type of fit
D* Flush fit (mm)
20 Proud fit (mm)
20
mounting
holes 582mm
650mm
min.
A (width) B (height)
600 893
568 885
561mm
596mm
mounting
holes 582mm
A (width) B (height)
600 1086
568 1078
561mm
596mm
C (depth)
581 min.
560 min.
mounting
holes 582mm
C (depth)
581 min.
560 min.
mounting
holes 582mm
mounting
holes 582mm