Using The Appliance - Electrolux EVE611SA User Manual

USING THE APPLIANCE

ImPorTAnT!
Pre-heating
Pre-heating the oven is recommended in several cooking
and grilling functions. Pre-heating the oven allows it to
reach the required temperature quickly and efficiently as
well as cook food at the correct temperature for the entire
cook time.
These models are equipped with a built-in rapid heat up
mode that activates each time you start an oven function.
During the rapid heat-up mode the heat comes from the
element surrounding the fan as well as the smaller element
above the food. This combination will heat up the oven
30% quicker than it would on standard 'Bake' function.
The oven will automatically revert to the set cooking
function once the preset temperature is reached.
Cooling / Vent fan
The appliance is fitted with a cooling fan. This prevents
the kitchen cabinet from overheating and reduces the
condensation inside the oven. It will operate whenever
the oven is in use and blow warm air across the top of the
oven door.
Note: If the oven is still hot from cooking, the cooling fan
will keep running to cool the oven down and will switch off
by itself once cool.
Condensation
Excess condensation may fog the oven door. This may
happen when cooking large quantities of food from a cold
start. minimise condensation by:
• Keeping the amount of water used whilst cooking to a
minimum.
• making sure the oven door is firmly closed.
• Baking custard in a baking dish that is slightly smaller
than the water container.
• Cooking casseroles with the lid on.
Note: If using water in cooking, this will turn to steam
and may condense outside your appliance. This is not a
problem or fault with your oven.
EVEP613SA, EVEP615SA, EVEP616BA, EVEP618BA 39
Cooking with the timer
The oven is equipped with a programmable controller that
can be used to turn the oven on and off automatically. The
'cook time' controls are used to automatically turn the oven
off after a set amount of time. The 'Delay End' controls are
used to set the time of day you want the cooking cycle
to finish.
Setting the cook time
1. Select the desired oven function and cooking
temperature.
2. Touch the 'cook time'
(or hold), until the desired cook time has been set.
3. Touch 'OK' or after 8 seconds from the last time
adjustment the oven will start cooking and the 'cook
time' display will countdown to zero.
4. The oven will turn off and beep when the 'cook time'
display reaches zero.
ImPorTAnT!
• When you use the 'cook time' function, the 'Finishes
at' display activates and tells you what time of day the
oven will turn off (based on the set cook time)
• During cooking, you can adjust the cook time with
the 'cook time' or
performance.
• When the cook time has elapsed, an audible signal
will sound for 2 minutes, the oven will switch off and
COOKING FINISHED will be displayed.
• To stop the audible signal, press any of the symbols
on the control panel.
• If you wish to cook a bit longer, press the 'cook time'
symbol for each additional minute you require.
The oven automatically reverts to the function and
temperature previously programmed. This feature is
available for 5 minutes after cooking has finished.
After that, the oven automatically switches off.
symbol as often as necessary
symbols for better cooking