Before Using The Appliance - Electrolux EVE611SA User Manual

BEFORE USING THE APPLIANCE

Preparing the oven
1. Please remove all stickers, leaflets and boxes from the
door and from the floor of the oven before operation.
2. Please wipe out the oven interior prior to operation
with warm soapy water and polish dry with a soft
clean cloth. Do not close the oven door until the oven
is completely dry.
3. Do not line the oven with foil. It will damage the
enamel.
Setting the time
Before the appliance, can be used, the time must be set.
• After the appliance has been electrically connected
'12:00' will be displayed and the
will flash.
• To set the time of day in hours and minutes touch the
+ –
or symbols. Refer to the diagram above.
• 5 seconds after the last change, the clock 'symbol will
disappear, confirming the time has been set. Once the
time has been entered, the clock advances minute by
minute.
Note: The clock has a 24 hour display.
ImPorTAnT!
New appliances can have a smell during first use. It
is recommended to 'run in' the oven before cooking
for the first time. Operate the oven, empty, at a
temperature of 180°C for approximately 2 hours
Please ensure the room is well ventilated during
this process.
Installing the oven accessories
• Catalytic liners
The oven will arrive with a catalytic fan baffle and top
panel already fitted. Optional side panels are also
supplied and may be fitted before installing the side
racks. The sole purpose of the side panels is to make
cleaning the oven easier. Omitting them will have no
effect on the cooking performance of the oven. They
can be fitted at any time by removing the side racks.
The catalytic liners supplied attach to the left and right
sides of the oven. Please note that there is a different
version for each side. They are marked 'LH' or 'RH'.
clock icon
1. Position the first liner as per the diagram. The black,
2. Line the hooks up with the slots provided in the oven
3. The access hole for the side racks should be visible
• Side racks
1. Insert the twin pegged side into the rear access holes
2. Then locate the front peg into the front access hole
shiny side of the liner should be facing the oven wall
with the hooks pointing down. Note that the diagram
shows the left hand liner. The right hand side will be a
mirror image of this.
wall, push them in and then allow the liner to slide
down to its final position. All four hooks mUST be
engaged in the slots.
when the liner is correctly positioned – see diagram.
provided, ensuring pegs are fully inserted.
and push in firmly.
EVE611SA, EVE614BA 7