Waste Ink Pads - Epson Stylus C58 Service Manual

Epson Stylus C58/C59/ME 2/C79/D78/C90/C91/C92/D92/T20/T20E/T23/T26/S20/T10/T11/ME 30/T21/T24/T27/S21

4.6.2 Waste Ink Pads

Part/Unit that should be removed before removing Waste Ink Pads
Upper Housing /Hopper /Main Board /Main Frame /EJ Frame Assy. /
Print Head /CR Scale/CR Motor/CR Unit/Timing Belt/Ink System/Power Supply
Board/EJ Roller/ASF Unit
Removal procedure
1. Remove the Waste Ink Pads (x7) from the sections indicated with
of the Frame Base.
Figure 4-90. Removing Waste Ink Pads
When removing the Waste Ink Pads, be careful not to tear the tip
C A U T I O N
of the induction paper. If it is torn, replace the induction paper.
When installing the Waste Ink Pads, be sure to insert ribs and
tabs of the Frame Base into the slots and notches of the pads.
When installing
sure to match the positioning tabs and press
to secure it in the right position.
DISASSEMBLY/ASSEMBLY
in the section (refer to Figure 4-91), be
until it clicks
Procedure Specific to Epson Stylus C58/C59/ME 2
When installing the Waste Ink Pads on the section
to lay the four parts one on top of another in the order shown
in the figure.
to
When installing the Waste Ink Pads on the section (B), make
sure to insert the tips of induction paper between the
After replacing the Waste Ink Pads, perform the following
A D J U S T M E N T
R E Q U I R E D
adjustment. (Refer to Chapter 5 "ADJUSTMENT")
1. "Waste Ink Pad Counter" (only after replacement)
2. "Ink Charge"
3. "TOP Margin Adjustment"
4. "Head Angular Adjustment"
5. "Bi-D Adjustment"
6. "PF Band Adjustment"
Figure 4-91. Installing Waste Ink Pads (1)
pads.
Tips of induction paper
Figure 4-92. Installing Waste Ink Pads (2)
Revision E
, be sure
and
67
Confidential