Epson Stylus C58 Service Manual page 58

Epson Stylus C58/C59/ME 2/C79/D78/C90/C91/C92/D92/T20/T20E/T23/T26/S20/T10/T11/ME 30/T21/T24/T27/S21
11. Remove the PE Detector Lever and Torsion Spring, 0.222.
Torsion Spring, 0.222
Figure 4-62. Removing PE Detector and Torsion Spring, 0.222
When installing the Extension Springs, follow the steps below.
1. Attach one end of the Extension Spring to the guide pin of the
Upper Paper Guide.
2. Attach the other end of the Extension Spring to the hook of the
Main Frame with the longnose pliers.
Extension Spring
Guide Pin
Figure 4-63. Installing Extension Springs
DISASSEMBLY/ASSEMBLY
PE Detector Lever
Hook
Disassembling Printer Mechanism
When securing the Main Frame to the Frame Base with
screws, be sure to perform the tightening in the order of the
numbers indicated in
When installing the Shield Plate L, be cautious not to damage
the Spur Gears of the PF Roller and the EJ Roller.
Install the Grounding Spring attaching the ends to the parts as
shown in the figure below.
Grounding Spring
Figure 4-64. Installing Grounding Spring
After replacing the Waste Ink Pads, perform the following
A D J U S T M E N T
R E Q U I R E D
adjustment. (Refer to Chapter 5 "ADJUSTMENT")
1. "Waste Ink Pad Counter" (only after replacement)
2. "Ink Charge"
3. "TOP Margin Adjustment"
4. "Head Angular Adjustment"
5. "Bi-D Adjustment"
6. "PF Band Adjustment"
Whenever the Main Frame is replaced, apply G71 grease
referring to Figure 6-12 (p.83)
Chapter 6.
Revision E
Figure 4-56 (p.56).
Notch (Main Frame)
Shaft (PF Roller)
and Figure 6-13 (p.83) in
Confidential
58