Disassembly Procedures - Epson Stylus C58 Service Manual

Epson Stylus C58/C59/ME 2/C79/D78/C90/C91/C92/D92/T20/T20E/T23/T26/S20/T10/T11/ME 30/T21/T24/T27/S21

4.2 Disassembly Procedures

This section explains the procedures for disassembling the product.
Unless otherwise stated, reassembly should be carried out in the reverse order of the
disassembly procedure.
For detailed engagement relations among main components, refer to the exploded
diagrams in the Appendix.
START
"4.3.1 Upper
Housing" (p38)
"4.5.2 Printhead"
"4.5.1 Hopper"
(p42)
"4.4.1 Main
Board" (p40)
"4.5.9 Main
Frame" (p56)
*"4.5.10 LD Roller/
ASF Unit" (p59)
*"4.5.11 Waste
Ink Pads" (p61)
DISASSEMBLY/ASSEMBLY
"4.5.3 CR Scale"
(p46)
(p43)
"4.5.4 CR Motor"
(p47)
"4.5.5 CR Unit/
Timing Belt"
(p48)
Figure 4-2. Disassembling Flowchart
Disassembly Procedures
Procedures partially different from model to model are described
C H E C K
in "Check Point" and "Reassembly".
P O I N T
"4.5.6 Ink System removal" (p51)
Ink System (Cap
"4.5.8 EJ Frame
Assy) (p51)
Assy/EJ Roller"
Roller" (p62)
Motor" (p63)
*Ink System
* The Shortest Way to Remove the Main Frame
(Pump Assy) (p51)
If the parts to repair is the ones marked with "*" in the flowchart
only, there's another way to remove the parts until the Main
Frame shown in the flowchart. Refer to
Remove the Main Frame. (p. 68) "
Note: Shown in the dotted-line is not the
shortest procedure, but is necessary to
proceed to the next step.
"4.5.7 Power
Supply Board"
(p54) (p53)
*"4.5.12 PF
*"4.5.13 PF
"4.7 The Shortest Way to
Revision E
37
Confidential