Tuning Step; Lock The Tuning Knob; Reset Button; Ssb (Single Side Band) Tuning - Tecsun S-2000 Owner's Manual

TUNING STEP

When you use the TUNING knob and the
FAST/SLOW tuning with the STEP button under the tuning knob. Short press the STEP button
with a "B" sound, the tuning step goes SLOW "
"BB" sound, the tuning step goes FAST "
FAST/SLOW tuning is shown in the chart below for each band.
STEP
BAND TUNING
FM 0.1 MHz
MW 9 /10kHz
LW
9 kHz
SW 5 kHz
AIR 0.025MHz

LOCK THE TUNING KNOB

If you want to LOCK the TUNING knob, press the STEP
button for about 3 seconds with a long "B--" sound, note
that " " shows on the display followed "
Press again the STEP button with a "B" sound to unlock
it and notice that "

RESET BUTTON

The reset button is located in the left under the TUNING knob. Press it only when the radio seems
to stop functioning properly to reboot the unit.

SSB (SINGLE SIDE BAND) TUNING

SSB enables listening to shortwave two way communications using the single sideband mode
such as amateur radio, Morse code, Weather-fax transmissions and other signals often referred
to as 'utility' signals.
To use the SSB control, turn on the TECSUN S-2000 and go into Short-wave. Press the SSB
button with a "B" sound and notice that USB appears in the display, to the right of SW.
Press the SSB button again with a "BB" sound and notice that LSB appears to the right of SW.
Press the SSB button with a long "B--" sound, it goes to AM mode and USB or LSB disappears.
USB is the abbreviation for Upper Sideband; LSB is the abbreviation for Lower Sideband. You
can now direct key in the SSB frequency you know to tune in
signals. Also notice that on the lower right front of the radio is
a control knob labeled SSB BFO. BFO stands for Beat
Frequency Oscillator. This control knob is used to fine tune
a sideband signal frequency.
(FAST)
TUNING
1MHz 0.01 MHz
100kHz
100kHz
100kHz
0.1MHz 0.001MHz
" disappears.
/ buttons to tune in stations you can select
"; short press the STEP button again with a
".
(SLOW)
0.1MHz
9 /10kHz
1kHz
9kHz
1 kHz
1 kHz 5kHz
0.025MHz
" or " ".
18
STEP button
" " shows on the display
USB or LSB shows