Lighting Your Grill - Bond GSF2818KH Owner's Manual

Table of Contents

DANGER:

Failure to open lid while igniting the grill's burners or not waiting five minutes to allow gas to clear if the grill does not light, may

result in an explosion, which could cause serious bodily injury or death.

WARNING:

Never stand with your head directly over the grill when preparing to light the main burners, to prevent possible bodily injury.

Lighting Main Burner

1. Open lid while lighting burners.

WARNING:

explosion.

Make sure there are no obstructions of airflow to the gas unit. Spiders and insects can

nest and clog the burner/venturi tube at the orifice. A clogged burner tube can lead to a

fire beneath the appliance.

2. All valves must be in the "OFF" position.

3. Open cylinder valve.

4. Ignite only the burners you wish to use, using the same method for each:

Push and turn desired burner valve knob and rotate slowly about 1/4 counterclockwise until a click

is heard. (See diagram to right.). The burner should be lit. If the burner does not light, repeat 2 or 3 more

times. If ignition does NOT occur in 5 seconds turn the burner controls to OFF, wait 5 minutes, and repeat the

lighting procedure. After burner is lit, repeat the procedure with any other burner desired.

5. Adjust valve knob(s) to desired cooking temperature.

Using the Lighting Stick to Light the Main Burners

1. Insert a match into the end of lighting stick locked in the drawer. Light the match.

2. Once lit, put the lighting stick through the cooking grid and place

the flame next to the burner ports found along the sides of the

desired burner (See diagram to right.)

3. Press the valve knob and rotate it counterclockwise to the ''HIGH''

position. The burner should light immediately. If more than one burner

is desired, repeat the procedure 2-3 until all desired burners are lit.

4. Adjust burners to the desired cooking temperature.

Precautions:

1. After lighting, observe the burner flame. Make sure all burner ports are lit.

2. If the burner flame goes out during operation, immediately turn the gas "OFF". Open lid to let the gas clear for at least 5

minutes before re-lighting.

3. Before cooking on the grill for the first time and operate the grill for approximately 15 minutes with the lid closed and the

gas turned on "HIGH". This will "heat clean" the internal parts, dissipate odor from the manufacturing process and painted

finish.

4. Clean the grill after each use. DO NOT use abrasive or flammable cleaners. This may damage parts of the grill and cause

a fire.

Lighting Side Burner

Open lid while lighting the burner. Lid must remain open while burner is lit.

Valve must be in the "OFF" position.

Open cylinder valve.

Push the side burner valve knob and rotate slowly about 1/4 counterclockwise until a click is heard. The burner should be

lit. If the burner does not light, repeat 2 or 3 more times. If ignition does NOT occur in 5 seconds turn the burner controls to

OFF, wait 5 minutes, and repeat the lighting procedure.

Adjust valve knob to the desired cooking temperature.

Using the Lighting Stick to Light the Side Burner

Open lid while lighting the burner. Lid must remain open while burner is lit

Remove the lighting stick then insert a match into the end of lighting stick. Light the match.

GSF2818KH

Owner's Manual