Table Of Zones; Shutdown Diagnostics - Viper 771XV Installation Manual

2. The lights will flash 4-times.
3. After 1-second the car will start and the timer mode will run for the specified time period.
The system is in Timer Mode. The engine may be allowed to run for its programmed run time, or the transmitter
can be used to shut down the engine. Either way, the remote start system will restart the engine again in three
hours. Timer Mode is exited automatically after the sixth run cycle.
T T o o e e n n t t e e r r o o r r e e x x i i t t t t i i m m e e r r m m o o d d e e m m a a n n u u a a l l l l y y : :
1. Make sure the remote start system is not operating the engine.
2. Turn the ignition on.
Timer Mode will be exited and the parking lights will flash four times.
t t a a b b l l e e o o f f z z o o n n e e s s
When using the Diagnostic functions, use the Table of Zones to see which input has triggered the system. It is
also helpful in deciding which input to use when connecting optional sensors and switches.
Z Z O O N N E E N N O O . . T T R R I I G G G G E E R R T T Y Y P P E E
1 Multiplexed Input
2 Multiplexed Shock Sensor Input Mux BLUE wire
3 Door Trigger
4 Multiplexed Shock Sensor
5 Ignition
6 Hood Trigger
N N O O T T E E : The Warn Away® response does not report on the LED.
s s h h u u t t d d o o w w n n d d i i a a g g n n o o s s t t i i c c s s
t t o o p p e e r r f f o o r r m m s s h h u u t t d d o o w w n n d d i i a a g g n n o o s s t t i i c c s s
1. With the ignition OFF, press and H H O O L L D D the Valet/Program button.
2. Turn the ignition ON and then back OFF while H H O O L L D D I I N N G G the Valet/Program button.
5 5 2 2
I I N N P P U U T T D D E E S S C C R R I I P P T T I I O O N N
BLUE (H1/6)
GREEN (H1/5) and VIOLET (H1/7)
Mux GREEN wire
Yellow ribbon harness wire
GRAY on the 6-pin shutdown harness
© 2005 Directed Electronics—all rights reserved