Table of Contents
Advertisement
H H 1 1 / / 6 6 B B L L U U E E ( ( - - ) ) t t r r u u n n k k i i n n p p u u t t , , z z o o n n e e 1 1
This wire is connected to the trunk pinswitch. If the trunk is open while the system is armed, this input will
trigger the security system This wire will report Zone 1.
H H 1 1 / / 7 7 V V I I O O L L E E T T ( ( + + ) ) d d o o o o r r t t r r i i g g g g e e r r i i n n p p u u t t , , z z o o n n e e 3 3
This wire is used in vehicles that have a positive (+) switched dome light circuit. Connect the violet wire to a
wire that shows (+)12V when any door is opened, and ground when the door is closed. This wire will report Zone 3.
H H 1 1 / / 8 8 B B L L A A C C K K ( ( - - ) ) c c h h a a s s s s i i s s g g r r o o u u n n d d c c o o n n n n e e c c t t i i o o n n
Connect this wire to a clean, paint-free sheet metal location (driver kick panel) using a factory bolt that DOES
NOT have any vehicle component grounds attached to it. A screw should only be used when in conjunction with
a two-sided lock washer. Under dash brackets and door sheet metal are not acceptable ground points. It is rec-
ommended that all remote start/security components be grounded at the same location.
2 2 0 0
© 2005 Directed Electronics—all rights reserved
Hide quick links:
Advertisement
Table of Contents
