Viper 771XV Installation Manual page 41

2. Then press the Valet/Program switch once more and H H O O L L D D it.
For example, if you just programmed the third feature in the menu and you would like to program the seventh
feature in the menu, you would press and release the Valet/Program switch four times and then press it once
more and H H O O L L D D it. The siren would chirp seven times to confirm access to the seventh feature.
T T o o s s e e l l e e c c t t a a n n o o t t h h e e r r m m e e n n u u : :
1. Press and hold the Valet/Program switch.
2. After three seconds, the unit will advance to the next menu and the siren will chirp, indicating which menu
has been accessed.
For example, if you just programmed some features in the first menu and you want to program a feature in the
third menu, press and H H O O L L D D the Valet/Program switch. After three seconds, the siren chirps twice indicating
access to the second menu. Continue to H H O O L L D D the button and three seconds later the siren will chirp three times
indicating access to the third menu. Features in the third menu are then programmable following steps 4 through
6 of the System Features Learn Routine procedure.
T T o o e e x x i i t t t t h h e e l l e e a a r r n n r r o o u u t t i i n n e e : :
The learn routine will be exited if any of the following occurs:
1. Close the open door.
2. Turn the ignition on.
3. There is no activity for longer than 15 seconds.
4. The Valet/Program switch is pressed too many times.
4 4 1 1
© 2005 Directed Electronics—all rights reserved