Viper 771XV Installation Manual page 40

T T o o e e n n t t e e r r t t h h e e S S y y s s t t e e m m F F e e a a t t u u r r e e s s L L e e a a r r n n R R o o u u t t i i n n e e ™ ™ : :
1.
2.
3.
4.
5.
N N o o t t e e : : Some features have more than two possible settings. Pressing
setting, pressing
6.
O O n n c c e e a a f f e e a a t t u u r r e e i i s s p p r r o o g g r r a a m m m m e e d d : :
■
Other features can be programmed within the same menu.
■
Another menu can be selected.
■
The learn routine can be exited if programming is complete.
T T o o a a c c c c e e s s s s a a n n o o t t h h e e r r f f e e a a t t u u r r e e i i n n t t h h e e s s a a m m e e m m e e n n u u : :
1. Press and release the Valet/Program switch the number of times necessary to advance from the feature you
just programmed to the next one you want to program.
4 4 0 0
O O p p e e n n a a d d o o o o r r . . ( ( The GREEN wire, H1/5, or the VIOLET, H1/7 must be connected.)
I I g g n n i i t t i i o o n n . . Turn the ignition on, then back off. (The heavy gauge PINK wire of the relay
satellite must be connected.)
S S e e l l e e c c t t a a M M e e n n u u . . Press and H H O O L L D D the Valet/Program switch. (The Valet/Program switch must
be plugged into the blue port.) After three seconds the siren will chirp once indicating
entry to the Basic Features Menu. If this is the menu you wish to access, release the button
and go on to Step 4. If the button is not released, you will jump to the next menu and the
siren will chirp twice. There are three possible menus. Once you have selected the desired
menu, release the Valet/Program switch.
S S e e l l e e c c t t a a F F e e a a t t u u r r e e . . Press and release the Valet/Program switch the number of times corre-
sponding to the feature you wish to change. For example, to access the third feature, press
and release 3 times. Then press the button once more and H H O O L L D D it. The siren will chirp the
number of times equal to the feature you have accessed.
P P r r o o g g r r a a m m t t h h e e F F e e a a t t u u r r e e . . While holding the Valet/Program switch, you can toggle the feature
on and off using the remote transmitter. Pressing the button that arms the system will
select the one chirp or default setting. Pressing the button that disarms the system (or the
Channel Two button when in the single button arm/disarm configuration) will select the
two chirp setting.
will toggle through the two-chirp and higher settings.)
R R e e l l e e a a s s e e . . Release the Valet/Program switch.
will select the one chirp
© 2005 Directed Electronics—all rights reserved