Table of Contents
Advertisement
[No link], [DIGITAL LINK], [LPM] or
Mode
[Ethernet] appears
[NO HDMI], [HDMI ON] or [HDCP
HDMI status
ON] appears.
The color of [Signal quality] will change to red, yellow
or green depending on the maximum and minimum
data of the ERROR value.
Signal quality
Color
less than -12 dB
Green
-11 ~ -8 dB
Yellow
more than -7 dB
Red
Projector name
You can change the projector name to be displayed
on the network.
1 )
Press ▲ ▼ to select [Projector name],
and press <ENTER> button.
2 )
Select characters with the ▲ ▼◄►
buttons and press the <ENTER>
button to enter the projector name.
Select [BS] to delete one character selected
with the cursor in the input box and press the
<ENTER> button.
3 )
Select [Set] with the ▲ ▼◄► buttons
and press the <ENTER> button.
Select [Cancel] to undo the changes and then
press the <ENTER> button.
4 )
Select [Yes] or [No] with the ▲ ▼
buttons and press the <ENTER>
button.
Note
[Name
] (
z
before the projector leaves the factory.
Network setup
You can make detailed wired LAN settings.
1 )
Press ▲ ▼ to select [Network setup],
and press <ENTER> button.
2 )
Press ▲ ▼ to select an item, and
change the setting according to the
instructions.
Status
Normal signal received
Part of the received data
destroyed
Abnormal signal received
is four-digit number) is set
DHCP
(DHCP client
function)
IP address
(Displaying and
setting the IP
address)
Subnet mask
(Displaying and
setting the subnet
mask)
Default gateway
(Displaying
and setting the
gateway address)
DNS1
(Displaying
and setting the
preferred DNS
server address)
DNS2
(Displaying
and setting the
alternate DNS
server address)
3 )
Press ▲ ▼◄► to select [Set], and press
<ENTER> button.
Default wired LAN settings
z
The following settings are set before the
projector leaves the factory.
DHCP
IP address
Subnet mask
Default gateway
DNS1/DNS2
Note
Before using the DHCP server, make sure the DHCP
z
server is already functioning.
For details of IP address, subnet mask, gateway and
z
DNS, ask the network administrator
Network
On:
If a DHCP server
exists in the
network to which
the projector is
connected, the
IP address will
automatically be
acquired.
Off:
If a DHCP
server does
not exist in the
network to which
the projector
is connected,
additionally set
[IP address],
[Subnet mask
] and [ Default
gateway ].
Enter the IP address
if DHCP server is not
used.
Enter the the Subnet
mask if not using a
DHCP server.
Enter the gateway
address if DHCP server
is not used.
Enter the DNS server
address if DHCP server
is not used.
Enter the alternate DNS
server address if DHCP
server is not used.
Off
192.168.10.100
255.255.255.0
192.168.10.1
NONE
.
ENGLISH -
63
Advertisement
Chapters
Table of Contents
