Table of Contents
Advertisement
Set [EAP], [USER NAME],
and [PASSWORD].
EAP
USER
NAME:
PASS
WORD:
Æ
1: "Glossary" (
page 115 – 116)
Note
If you are unable to connect to the wireless LAN
z
through the access point even after performing the
steps in "Projector settings (
manufacturer of the access point.
When using EAP, the projector needs to be set according
z
to the setting of the RADIUS server. Check with the
network administrator for the setting of the RADIUS
server.
When using an EAP together with an access point with
z
invalid SSID broadcast, select WAP-EAP or WAP2-EAP
for the authentication method even if the authentication
method of the access point is WPA-EAP/WPA2-EAP.
Default settings of [USER 1]~[USER 3]
„
The following settings as [USER1]~[USER3] in the
wireless LAN are set before the projector leaves
the factory.
SSID
Panasonic Projector
DHCP
Off
IP address
192.168.11.100
Subnet mask
255.255.255.0
:
Select the EAP
1
setup in the
RADIUS server
. Types of
1
EAP that can be
selected are as
follows.
PEAP
(MS-
1
CHAPv2
),
1
PEAP
(GTC
1
),
1
EAP-TTLS
(MD5
),
1
1
EAP-TTLS
(MS-CHAPv2
1
), EAP-FAST
1
(MS-CHAPv2
1
), EAP-FAST
1
(GTC
)
1
1
Input a user
name used for
authentication
(excluding
spaces)
(maximum 64
characters).
Input a password
used for
authentication
(maximum 64
characters).
Æ
page 74)", contact the
Default gateway
192.168.11.1
Mode
AD HOC
Authentication
OPEN
Encryption
NONE
Channel
11
DNS 1/DNS 2
NONE
5 )
Press ▲ ▼◄► to select [Set], and press
<ENTER> button.
Save the current network settings
Note
When configuration is completed, you need to select [Set]
z
and press the <ENTER> button. At this point, select [Back]
to go back to the previous screen (2/3), or select [Cancel]
to cancel the configuration change.
Sending image from iPad / iPhone /
„
iPod touch
By using the dedicated application, you can send the
PDF file or the JPEG image which stored on your iPad
/ iPhone / iPod touch to the projector for projecting.
For details, please enter the following URL.
http://panasonic.net/avc/projector/
Projector name
You can change the projector name to be displayed
on the network.
1 )
Press ▲ ▼ to select [Projector name],
and press <ENTER> button.
2 )
Select characters with the ▲ ▼◄►
buttons and press the <ENTER>
button to enter the projector name.
Select [BS] to delete one character selected
with the cursor in the input box and press the
<ENTER> button.
3 )
Select [Set] with the ▲ ▼◄► buttons
and press the <ENTER> button.
Select [Cancel] to undo the changes and then
press the <ENTER> button.
4 )
Select [YES] or [No] with the ▲ ▼
buttons and press the <ENTER>
button.
Note
□□□□ ] ( □□□□ is four-digit number) is set
[Name
z
before the projector leaves the factory.
Network
69
ENGLISH -
Advertisement
Chapters
Table of Contents
