Table of Contents
Advertisement
CONTROL BOARD
HARNESS
3.
Lifting the cover and noting their locations, firmly
but gently disconnect the control board harness, the
wire at the interlock switch, and the key switch wires.
Remove the rear cover. NOTE: Illustration does not
show control board insulator.
4.
Remove four Phillips head screws and the power
supply board from the rear cover.
5.
Installation is the reverse of removal.
Section D – Electrical Components
INTERLOCK
SWITCH
WIRE
KEY SWITCH
WIRES
SCREWS
Control Board
REMOvE AND RE-INSTALL
The control board is used to electronically connect the
compactor's electronic components.
CONTROL
PANEL
1.
Remove the control panel assembly (see Control
Panel Assembly, Remove and Re-install). Remove
rear cover from the display module assembly (see
Display Module Assembly, Remove and Re-install).
WIRE
CONNECTOR
SCREWS
2.
Remove the wire harnesses from control board (Note
wire locations).
NOTE: In this illustration, the key switch and control
board insulator have been removed for clarity.
3.
Remove six Phillips head screws, the printed circuit
board, and the insulator from the display module
frame.
4.
Installation is the reverse of removal.
SCREWS
CONTROL
BOARD
DISPLAY
PANEL
27
Advertisement
Table of Contents
