Table of Contents
Advertisement
Available languages
Available languages
Power supply cord strain relief:
I Remove the screws from a 3/4" (19 mm)
UL listed strain relief (UL marking on strain
relief). Put the tabs of the two clamp
sections into the hole below the terminal
block opening so that one tab is pointing
up and the other is pointing down, and
hold in place.
Tighten strain relief screws enough to hold the
two clamp sections together.
14
A. Strain relief tab
A
pointing up
B. Hole below terminal
block opening
B
C. Clamp section
D. Strain relief tab
C
pointing down
D
I Put power supply cord through the strain
relief. Be sure that the wire insulation on
the power supply cord is inside the strain
relief. The strain relief should have a tight
fit with the dryer cabinet and be in a
horizontal position. Do not further tighten
strain relief screws at this point.
5. Now complete installation following
instructions for your type of electrical
connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
Advertisement
Table of Contents
