Connecting An Hdmitm Or Dvi Device To The Hdmi Input - Toshiba 40RV52R Owner's Manual

HDMI, the HOM I logo and High-Definition Multimedia Interface are
trademarks or registered trademarks of HOM I Licensing LLC
[1] EIA/CEA-861-D compliance covers the transmission of
uncompressed digital video with high-bandwidth digital content
protection, which is being standardized for reception of high-
definition video signals. Because this is an evolving technology, it
is possible that some devices may not operate properly with the
TV.
02][111111---"
d
C'J
CJ
TV back panel
, - - - - - HDMIIN - - - - ,
H~ml
1 2
Note: To ensure that the HOMI or OVI device is reset properly,
it
is recommended that you follow these procedures:
• When turning on your electronic components, turn on the
TV first, and then the HOMI or OVI device.
• When turning off your electronic components, turn off the
HDMI or DVI device first, and then the TV.
To connect a DVI device, you will need:
• one HDMI-to-DVr adapter cable (HOMI type A connector)
per DVI device
- For proper operation, the length of an HOMI-to-OVI
adapter cable should not exceed 9.8 ft (3m) The
recommended length
is
6.6 ft (2m)
• one pair of standard analog audio cables per DVI device
- An HOMI-to-OVI adapter cable transfers video only
Separate analog audio cables are required (see
illustration)
- See "Setting the HOMITM audio mode"
(1&
page 31)
HOMI device
VIDEO
I AUDIOs
• HOMl OUT.
[e~
~~~
m ..
I- CQIII
[e~ ~~+
L R
-
To connect an HDMI device, you will need:
one HDMI cable (type A connector) per HDMI device
- For proper operation, it is recommended that you use an
HOMI cable with the HOMI Logo (Hi:Jml )
- To display an 1080i/60Hz signal format, you will need a
Category 2 cable. Conventional HOMI/OVI cable may
not work properly
- HOMI cable transfers both video and audio. Separate
analog audio cables are not required (see illustration).
- See "Setting the HOMITM audio mode"
(1&
page 31).
T
I5
V back
pa~~~I~
1 2 3
C:'i.
Cl..
~~.
\
' ,
Connecting an HDMITM or DVI
device to the HDMI input
The HDMI input on your TV receives digital audio and
uncompressed digital video from an HOMI source device,
or uncompressed digital video from a DVI (Digital Visual
Interface) source device.
This input is designed to accept HDCP (High-Bandwidth
Digital-Content Protection) program material in digital form
from EIA/CEA-861-D-compl iant
lll
consumer electronic
devices (such as a set-top box or DVO player with HDMI or
DVI output).
The HDMI input can accept and display VGA, SVGA, XGA,
WXGA, SXGA, 480i (60Hz), 480p (60Hz), nop (60Hz),
I080i (60Hz) and I080p (24Hz/60Hz) signal formats. For
detailed signal specifications, see page 56.
Supported Audio format: Linear PCM, sampling rate 32/44.1/
48 kHz
Note: To connect a PC to the HOMI input, see page 18.
To view the HDMI device video:
Select the HDMI I, HOMI 2 or HOMI 3 video input source
on the TV.
*
'" To select the video input source, press INPUT on the remote control
(1& page 20). To program the TV remote control to operate other
devices, see Chapter 3.