Woods RD990X Operator's Manual page 33

1. A-Frame Arm
2. Sleeve, .94 x 1.44 x 2.75 (Cat 2 Only)
3. Sleeve, .94 x 1.44 x 1.94 (Cat 1 Only)
4. Sleeve, .81 x 1.25 x 2.12
5. Sleeve, .88 x 1-1/8 x 19/32
6. 3/4 Flat Washer
7. 3/4 NC x 5-1/2 HHCS GR5
8. 3/4 NC Hex Nut
9. 1/2 Flat Washer
10. 1/2 NC x 6 HHCS
11. 1/2 NC x 2 HHCS
12. 3/8 Chain, 38-Link
Install Quick Hitch (Optional)
NOTE: This kit allows mower to fit Category 1 or
Category 2 standard quick hitches.
1. Lower hitch arms must be located in center
attachment hole. See Figure 34 for adjustment.
2. For use with Category 1 quick hitch, lower hitch
arms should be positioned with offset toward inside
of mower. For use with Category 2 quick hitch,
lower hitch arms should be positioned with offset
toward outside of the mower.
3. Remove clevis pins from lower hitch arms. Pins will
not be used for quick hitch.
4. Attach A-Frame arms (1) and sleeve (2) to lower
hitch arms using cap screws (7), sleeve (5),
washers (6) and hex nut (8).
MAN0845 (1/12/2011)
Figure 34. Quick Hitch Kit Installation (Optional)
5. Attach upper end of A-Frame arms (1) and sleeve
(4) to U-bracket, using cap screw (7), washers (6)
and hex nut (8).
6. Remove rear offset links. They will be replaced
with chains (12).
7. Attach chains (12) to top of A-frame on both sides
as shown, using cap screw (10), washers (9), and
flange lock nut.
8. Attach opposite ends of chains (12) to rear mower
frame using cap screws (11), washers (9), and
flange lock nut. Vary length slightly as desired.
Twist chain to make finite adjustments in length
until unit lifts level.
9. Tighten all hardware.
Assembly 33