Woods RD990X Operator's Manual page 30

Install Front Casters ( Figure 28 & 29)
1. Remove cap screws (12 & 13) and lock nuts (15)
from outer caster arms (10).
2. Place arms inside of pockets in front corners of
deck. Replace hardware.
10. Caster arm
12. 1/2 NC x 1-1/2 HHCS
13. 1/2 NC x 4 HHCS
15. 1/2 NC Flange lock nut
18. Lug
19. 1/2 NC x 4-1/2 HHCS
Figure 29. Caster Arm Assembly
Torque Caster Arms
1. Place mower on a hard level surface.
2. Loosen cap screws and lock nuts on all four caster
wheel arms. This allows clearance in the caster
wheel assemblies to be equalized.
3. Torque all cap screws and nuts to 85 lbs-ft.
Install Hitch Arms
1. Remove cap screws, lock nuts and hitch arms (E)
from lower hitch arm attachment point (D).
2. Position arms according to Figure 30 and replace
hardware.
30 Assembly
1. Tractor top link
A. Mower top link attachment point
B. Mower hitch pin
C. Category 2 sleeve
D. Lower hitch arm attachment point
E. Mower hitch arm
Figure 30. Hitch Arm Installation
MAN0845 (1/12/2011)