Thermos 461410708 Product Manual page 8

CAUTION
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
Match Lighting
1. Open lid during lighting.
2. Match holder is on the left rear leg. Attach match to match
holder, light match. Place match into match lighting hole from
outside of grill bottom (as shown).
3. Push in and turn left knob to . Be sure burner lights and
stays lit.
4. Push in and turn other knob to .
Match-lighting hole is
on side of grill bottom
• Sideburner Use
Do not use a cooking pot larger th n 9"
from sideburner before using griddle. Do not close lid when
using griddle.
8 • 461410708
a on grid Remove grid .
Griddle
Grid
Match Lighting
1. Open lid.
2. Hold lit match to any port on the burner. Push in and turn
sideburner knob to HIGH . Be sure burner lights and stays lit.
Burner Flame Check
• Remove cooking grates and flame tamers. Light burners, rotate
knobs from HIGH to LOW. You should see a smaller flame in
LOW position than seen on HIGH. Always check flame prior to
each use. If only low flame is seen refer to "Sudden drop or low
flame" in the Troubleshooting Section.
Before Your First Cookout
•
Light burners, check to make sure they are lit, close the lid and
warm up grill on HIGH for 15 minutes. Curing of paint and parts
will produce an odor only on first lighting.
Turning Grill Off
OFF
• Turn all knobs to position. Turn LP cylinder off by turning
hand-wheel clockwise to a full stop.
Ignitor Check
• Turn gas off at LP cylinder. Press and hold electronic ignitor
button. "Click" should be heard and spark seen each time
between burner and electrode. See "Troubleshooting" if no click
or spark.
Valve Check
• Important: Make sure gas is off at gas source before
checking valves. Knobs lock in
valves, first push in knobs and release, knobs should spring
back. If knobs do not spring back, replace valve assembly
before using grill. Turn knobs to LOW position then turn back to
OFF
position. Valves should turn smoothly.
Hose Check
• Before each use, check to see
if hoses are cut, worn or kinked.
Replace damaged hoses before
using grill. Use only
hose specified by manufacturer.
HI
LO
OFF
position. To check
Normal Kinked
Hose Hose